# 3. Label Printing

Connect and configure supported DYMO label printers.

# How to enable a DYMO label printer and choose label size

Enable DYMO printing on a computer connected to a supported DYMO printer and running the required DYMO software.

## Configure DYMO

1. Connect and power on the DYMO printer.
2. Confirm DYMO Connect is installed and can see the printer.
3. Open **Settings > Devices & Hardware**.
4. Enable **DYMO Printer**.
5. Select **Big**, **Small**, or **Mini** to match the installed label roll.
6. Save the settings.
7. Print a test label from the workflow that will use it.

This is a device-specific setting and must be configured on each computer that prints labels.

# How to troubleshoot DYMO label printing

If a DYMO label does not print correctly, verify the hardware, software, and label configuration in order.

## Troubleshooting checklist

- Confirm the printer is powered on and connected to this computer.
- Open DYMO Connect and verify that it recognizes the printer.
- Confirm DYMO is enabled in Devices & Hardware.
- Match the selected label size to the roll installed in the printer.
- Check label orientation and clear any jam.
- Reload RepairNest POS after reconnecting the printer.
- Try a controlled test label before printing a large batch.