3. Label Printing
Connect and configure supported DYMO label printers.
How to enable a DYMO label printer and choose label size
Enable DYMO printing on a computer connected to a supported DYMO printer and running the required DYMO software.
Configure DYMO
- Connect and power on the DYMO printer.
- Confirm DYMO Connect is installed and can see the printer.
- Open Settings > Devices & Hardware.
- Enable DYMO Printer.
- Select Big, Small, or Mini to match the installed label roll.
- Save the settings.
- Print a test label from the workflow that will use it.
This is a device-specific setting and must be configured on each computer that prints labels.
How to troubleshoot DYMO label printing
If a DYMO label does not print correctly, verify the hardware, software, and label configuration in order.
Troubleshooting checklist
- Confirm the printer is powered on and connected to this computer.
- Open DYMO Connect and verify that it recognizes the printer.
- Confirm DYMO is enabled in Devices & Hardware.
- Match the selected label size to the roll installed in the printer.
- Check label orientation and clear any jam.
- Reload RepairNest POS after reconnecting the printer.
- Try a controlled test label before printing a large batch.